Notifier VGM NION UniNet 2000, Инструкция по эксплуатации

Страница: 13 / 28

13
Document 52002 VGM NION Instruction Manual Rev. A 09/11/02
1.9 Connections to the VGM NION
The NION must be connected to the Vista Gateway Module. Connect Echelon wires from the network transceiver
on the NION to terminals seven and eight on the VGM.
VGM NION
(NION-SPB)
SMX transceiver
Vista Gateway Module
1.10 Software Replacement/Upgrade Installation
When replacing or upgrading the software and network PLCCs, execute the following steps:
1. Disconnect all power to the NION-SPB. IMPORTANT: Always exercise ESD precautions when
directly handling the NION-SPB or any other hardware.
2. Place the flash modules in their respective sockets according to the figure below. Orient the notch on the
chip with the notch in the socket.
3. Re-apply power to the NION.
Network Communication PLCC (U24)
Application PLCC (U6)
Figure 1-10: NION Software Replacement
NOTE: Use only wire for power limited systems. Power limited wire
runs use type FPLR, FPLP, FPL or equivalent cabling per NEC 760.
Figure 1-9: VGM NION Network Connection to Vista Gateway Module
B
A
www.PDF-Zoo.com
firealarmresources.com