Notifier VGM NION UniNet 2000, Инструкция по эксплуатации

Страница: 9 / 28

9
Document 52002 VGM NION Instruction Manual Rev. A 09/11/02
1.2 NION-SPB Connectors
Power Connector (TB5 ) - +24VDC input power connector.
TB6 - Relay output; both Normally Open/Normally Closed are available.
TB1 - Standard terminal block style port for EIA-232 connection to serial channel A.
Echelon Network Transceiver Connector(J1) - Pin connection header for SMX Transceiver.
Reset Pin (SW1 ) - Resets the NION and restarts the software.
Bind Pin (SW2) - Sends a message to the Local Area Server requesting to be added to the network.
Battery Terminal (BT1) - 3V Lithium battery terminal.
Network Communication PLCC (U24) - The flash module that specifies the network transceiver.
Application PLCC (U6) - The flash module that contains the application software.
Environmental Requirements
The NION-SPB can be installed in the following environmental conditions:
• Temperature range of 0ºC to 49ºC (32°F - 120°F).
• 93% humidity non-condensing at 30ºC (86°F).
1.4 Cabinet Mounting Information
NISCAB-1 Installation
The NION-SPB board can be mounted stand-alone in a single node enclosure, the NOTIFIER® NISCAB-1, where
power is supplied by the monitored equipment or an external source. The NISCAB-1enclosure is provided with
door and key lock.
Mounting the enclosure to its wall position
1) Use the provided key to unlock the enclosure cover.
2) Remove the enclosure cover.
3) Mount the enclosure to the wall. Refer to the enclosure mounting hole layout in Figure 1-3.
1.3 Required Components
• NION-SPB
• SMX Transceiver (FTXC)
• Software kit for VGM NION interface
• Enclosure (NISCAB-1)
The following paragraphs describe all required and optional components used to assemble a functional VGM
NION. All of the items described must be ordered separately.
www.PDF-Zoo.com
firealarmresources.com