Nortel Passport 8250, Руководство по интерфейсу командной строки

Страница: 61 / 94

Chapter 4 Other activities in the CLI 61
Passport 8250 Command Line Interface Guide R2.2
Viewing entries in the fault log
The faultlogview command displays entries in the fault log.The syntax of the
command is:
faultlogview [<entry#>]
where
[<entry#>]
is an entry number between 1 and 24 in the fault log
Note: Entering the faultlogview command without the [<entry#>]
parameter displays all the fault log entries.
Procedure
1 Display the entries in the fault log:
faultlogview [<entry#>]
Example
The following is an example of displaying the entries in the fault log. There
are three entries.
[Edgeplex CLI]: faultlogview
Entry 1: TimeStamp (0d: 0h: 1m:11s), Board (1), Fault
Id (7)
Entry 2: TimeStamp (0d: 0h: 0m: 0s), Board (1),
Machine Check
Entry 3: TimeStamp (0d: 0h: 3m:10s), Board (1), Fault
Id (4)
Example
The following is an example of displaying the most recent fault that was
generated from the system.
[Edgeplex CLI]: faultlogview 1
Entry # : 1
Time stamp : 0d: 0h: 0m: 0s
Board # : 1
Machine check exception number : 512
Offending task : "tWdbTask"
Program counter register : 0x000fa3a8
Data access register : 0x203e6f14
Data storage interrupt status register : 0x0001812b
Machine status register : 0x00009020