Nortel Passport 8250, Руководство по интерфейсу командной строки

Страница: 33 / 94

Chapter 3 Provisioning ports and connections 33
Passport 8250 Command Line Interface Guide R2.2
Changing port configuration settings
Procedure
1 Ensure that you are accessing the correct service board number.
See “Accessing a board in the CLI” (page 24) for information on changing
board numbers.
2 Change the port configuration settings:
portconfig [<port#> [lineType=<value>]
[lineCoding=<value>][SignalMode=<value>]]
See Table 3 “Portconfig command parameters” (page 32) for the values
for the portconfig parameters.
Example
The following is an example of changing the signal mode on port 2, service
board 3 for an E1 CAS connection. The signal mode changes from none to bit
oriented.
[Edgeplex CLI]: 3
[E1-3]: portconfig 2 signalMode=BITORIENTED
Viewing port configuration settings
The portconfig command used without the parameters displays the line type,
line coding, signal mode, and status for all DS-1/E1 ports on a service board.
The status parameter is the alarm status for a port. See “Status command
parameter” (page 33) for the values for the status parameter.
Table 4
Status command parameter
Number Definition
1 No alarm present
2 Far end loss of frame (LOF)
4 Near end sending LOF indication
8 Far end sending alarm indication signal (AIS)
16 Near end sending AIS
(Sheet 1 of 2)