Nortel CallPilot 1001rp, Руководство по установке и настройке

Страница: 323 / 368

October 2002 Maintaining the Pentium II SBC card
Part 5: 1001rp Server Maintenance and Diagnostics 323
6 Remove the I/O bracket.
Note: You may need to remove additional cards inserted beside the SBC
to have access to the bracket. This step is also optional as explained in
the note to the previous step.
7 Remove the screw located at the top of the card’s faceplate.
8 Loosen the SBC.
Hold the SBC card at the front and rear ends, and slowly pull it halfway
up from the slot.
9 Without removing the card completely, do the following:
a. Disconnect the keyboard/reset cable from under the processor unit.
b. Disconnect the serial port cables.
Label and remember where PIN 1 goes.
10 Pull the card out of the chassis.
11 Unscrew the media drive bay and slide it out a little.
Do not force it out.
12 Disconnect the IDE floppy disk drive, the CD-ROM drive, and the tape
drive power and I/O cables.
Label each cable so you remember where to reconnect it when
reassembling the pieces.
13 Slide the media drive bay out of the server.
14 Disconnect the IDE CD-ROM cable and discard it.
Note: This is a grey cable 55.9 cm (22 inches) in length. When
reconnecting, use the new IDE blue cable provided. The new IDE cable
is 78.7 cm (31 inches) in length.
15 Route the new 78.7 cm (31-inch) IDE blue cable from the media bay up
through the slot in the metalwork and to the location of the SBC slot.
ATTENTION
Ensure that the EMI gasket (where the metal bracket is
located) is not damaged when pulling the card out.