Nortel CallPilot 1001rp, Руководство по установке и настройке

Страница: 294 / 368

Maintaining the Pentium II SBC card Standard 1.0
294 CallPilot
Dual Inline Memory Modules
Introduction
Dual Inline Memory Modules (DIMMs) are the memory modules located on
the SBC. The gold-plated edge connectors on DIMMs are designed to plug
into matching edge-connector slots. The design allows you to add or remove
these modules repeatedly without tools or damage. Install DIMMs on the
Pentium II SBC only.
Capacity
Use 168-pin Fast Page Mode (FPM) parity DRAM utilizing DIMM
technology with 60ns access times. A module has a capacity of 32, 64, or
128 Mbytes. DIMMs require only one slot filled to compose a bank. There
are four slots or banks on the SBC. Install DIMMs in any slot, combination,
or order. It is recommended that bank 0 (DIMM 1) be filled to enable
troubleshooting procedures. Install up to 512 Mbytes of memory.
Requirements
To add DIMMs to the card, you require the following:
an antistatic wrist strap
DIMMs with gold-plated edge connectors
To add DIMMs to the SBC card
Note: The illustration of “The Pentium II SBC” on page 297 shows the
location of the DIMM slots.
1 Remove the SBC card from the server.
Note: To remove old DIMMs, perform steps 2 and 3. To add new DIMMs,
go to step 5.