Nortel CallPilot 1001rp, Руководство по установке и настройке

Страница: 215 / 368

October 2002 Performing RAID maintenance
Part 5: 1001rp Server Maintenance and Diagnostics 215
11 Repeat steps 6 to 10 for the fifth and sixth hard drives.
Result: The pre-upgrade hard drives (fourth, fifth, and sixth) are online,
and the first three hard drives are disconnected and offline.
12 Press Esc to return to the administration pop-up menu.
Result: You return to the administration pop-up menu.
13 Press Esc to return to the main menu.
Result: You return to the main menu.
14 Press Esc to return to the RAID controller selection window.
Result: You return to the RAID controller selection window.
15 Press Esc to exit the Mylex RAID EzAssist program.
Result: A message appears indicating that you are about to exit RAID
EzAssist and asking for confirmation.
16 Select Yes, and then press Enter.
Result: A message appears indicating that you can either power off the
system or select OK to reboot.
17 Power off the server.
To verify that the pre-upgrade hard drives are functioning
properly
1 Power up the CallPilot server, and then log on to Windows NT.
2 Wait for the System Ready Indicator dialog boxes to indicate that
CallPilot is ready to accept calls. This can take up to 15 minutes.
3 Test the CallPilot system. See Chapter 5, “Testing the CallPilot
installation,” in Part 3 of the
CallPilot Installation and Configuration
binder.
4 Do one of the following:
If the system is still not working properly, then there may be a RAID,
hard drive, or software problem with the old data. Contact Nortel
Networks technical support.