Multi Variable Heat Pump Floor and Ceiling Type Indoor Unit
1
1 Safety Precautions
WARNING
(1) Follow this instruction to complete the installation work. Please read this manual carefully before unit startup and
service.
(2) Wire size of power cord should be sized correctly. The damaged power cord and connection wire should be replaced by
specialized cable.
(3) After connecting the power cord, please affix the electric box cover properly.
(4) Never fail to comply with the nitrogen charge requirements.Charge nitrogen when welding pipes.
(5) Never short-circuit or cancel the pressure switch to prevent unit damage.
(6) Connect the wired controller before energization; otherwise wired controller could be damaged.
(7) Before using the unit, please check if the piping and wiring are correct to avoid water leakage, refrigerant leakage,
electric shock, or fire etc..
(8) Do not insert fingers or objects into air outlet/inlet grille.
(9) Open the door and window and keep good ventilation in the room to avoid oxygen deficit when the gas/oil heating
equipment is used.
(10) Never start up or shut off the air conditioner by plugging or unplugging the power cord.
(11) Let the unit run for at least five minutes after startup; otherwise it will affect oil return of the compressor.
(12) Do not allow children operate this unit.
(13) Do not operate this unit with wet hands.
(14) Turn off the unit or cut off the power supply before cleaning, otherwise electric shock or injury may occur.
(15) Never spray or flush water towards unit, otherwise malfunction or electric shock may occur.
(16) Do not expose the unit to the wet or corrosive circumstances.
(17) Under cooling mode, please don't set the room temperature too low. Keep the temperature difference between indoor
and outdoor unit within 5°C (9°F).
(18) User is not allowed to repair the unit. Faulty service may cause electric shock or fire. Please contact a qualified service
technician for help.
(19) Before installation, please check if the power supply matches the requirements specified on the nameplate.
(20) Installation should be conducted by dealer or qualified personnel. Please do not attempt to install the unit yourself.
Faulty installation may result in water leakage, electric shock or fire etc..
(21) Be sure to use the appropriate accessories and parts to prevent the water leakage, electric shock and fire accidents.
(22) Make sure the unit can be grounded properly and securely to avoid electric shock. Please do not connect the ground
wire to gas pipe, water pipe, lightning rod or telephone line.
(23) Connect power to the unit 8 hours before operation. Do not cut off the power when it will not be used for a short period
of time, i.e. overnight (to protect the compressor).
(24) If refrigerant leakage occurs during installation, please ventilate immediately. Toxic gas will resuslt if the refrigerant gas
meets spark or open flame.
(25) Volatile liquid, such as paint thinner or gasoline will damage the unit appearance.Only use soft cloth with a little mild
detergent to clean the outer casing of unit.
(26) If anything abnormal occurs (such as burning smell), please power off the unit and cut off the main power supply, and
then immediately contact a licensed contractor. If the problem persists, the unit might be damaged and lead to electric
shock or fire.
