Nordson R3V, Руководство по эксплуатации

Страница: 70 / 146

RV Series Automated Dispensing Systems
70 www.nordsonefd.com info@nordsonefd.com +1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
How to Dispense on Multiple Workpieces in an Array
Use the Step & Repeat commands to dispense the same pattern on multiple workpieces in an array.
NOTE:
You can use the Step & Repeat Block icon to disable dispensing for workpieces not present. Refer to “How
to Disable Dispensing for Specific Workpieces in an Array” on page 71.
PREREQUISITES
‡
The system is properly set up. Refer to “Setting Up and Calibrating the System (Required)” on page 45.
‡ If the tip or any element of the Z axis head was changed, repeat system setup and calibration using the Robot
Initial Setup wizard. Refer to “Setting Up the System Using the Robot Initial Setup Wizard” on page 48.
‡
The system is in the CCD Mode.
‡
Multiple workpieces are properly positioned on the fixture plate.
#
Click Step
1
>
• Click the PROGRAM tab, then click the Example icon and select FIND MARK
+ STEP REPEAT. Click YES when prompted for confirmation.
A sample Step & Repeat X program appears.
NOTE:
You can also use Step & Repeat Y to dispense onto multiple pieces
in an array. Refer to “Appendix A, Command Function Reference” on
page 98 for detailed information on both Step & Repeat commands.
2 • Jog the dispensing tip to the first workpiece in the array and create a mark.
Refer to “How to Create a Mark” on page 72 as needed.
3 • Click the FIND MARK command and enter the number of the mark created in
step 2.
4 • Click the remaining commands and enter the parameters that will work
for your array. Refer to “Appendix A, Command Function Reference” on
page 98 for detailed information on commands.
5 • Click END PROGRAM to end the program.
6
or
• Test the program and make adjustments until the program runs correctly.