Nordson Encore Select HD, Руководство пользователя по изделию

Страница: 17 / 57

© 2022 Nordson Corporation
1620445-03
3-3 Setup
Dual Spray Gun System Connections
WARNING: This diagram does not show system grounds. All conductive equipment in
the spray area must be connected to a true earth ground.
NOTE: Refer to manual 1604870,
Encore HD and XT Manual Powder Spray System
Controller
for more information about the controller.
Figure 3-3 shows a typical dual robot spray gun system and the connections required for
CAN communication between the Encore Controller Interface and the customer PLC.
Configuration of the Encore Controller Interface and the iFlow
®
module PCA inside the
Encore HD pump control unit must be completed during system installation.
See table on page 7-10 for system component part numbers.
AFC
STD
M /HR
uA
GUN CONTROL
EncoreTM
3
KV
SCFM
%
AFC
STD
M /HR
uA
GUN CONTROL
EncoreTM
3
KV
SCFM
%
1 1
2 2
4 4
8 8
5
6
5
7
5
6
5
7
Power
Power
iFlow Module
PCA
3
Customer PLC
(Drop)
(Drop)
Terminate
Terminate
F F
M
F
F
M
Power
Figure 3-3 Connections for 2 Spray Gun Robot Systems
1. Encore Select HD Robot spray gun
2. Encore controller interface
3. Control unit, PLC gateway 4. Encore robot cable
5. Controller interface cable
6. DeviceNet 5-pin cable Tee 7. Encore HD pump control unit
8. Network cable