Nordson Encore Select HD, Руководство пользователя по изделию

Страница: 31 / 57

© 2022 Nordson Corporation
1620445-03
5-3 Repair
Power Supply Replacement
NOTE: If replacing powder path, skip this procedure.
1. See Figure 5-3. Slide the power supply (6A) out of the gun body (6B).
2. Check the gasket (8) on the back of the bulkhead (9). Replace it if it is damaged. The
gasket is attached to the bulkhead with pressure-sensitive adhesive.
6A
8
9
6B
Figure 5-3 Power Supply Replacement
3. Slide the new power supply into the upper cavity of the gun body, guiding the gun
body ribs between the raised grooves on the top of the power supply.
4. Press on the end of the power supply to ensure that the power supply contact tip is
firmly seated against the spring contact inside the gun body.
5. Route the power supply harness connector through the top hole in the bulkhead.