Nordson Encore LT, Руководство по эксплуатации продукта

Страница: 18 / 92

System Setup
3-2
Part 1604857-04
E 2014 Nordson Corporation
Controller Rail Mounting
(contd)
4. Install the rail bracket over the operator platform railing (6), tighten the
screws (3) against the rail, then tighten the jam nuts (4) up against the
rail bracket to prevent the screws from loosening.
5. Install the parts tray (11) in the front two holes on top of the controller
using two of the M5 screws (2) in the controller top, and one #10 dished
lock washer (9) included in the kit.
6. Use the bus-bar grounding kit to connect the controller ground stud to
the booth base, as described in the grounding kit instructions.
Controller Wall Mounting
See Figure 3-2. Wall-mount systems are shipped with a bracket kit that
includes the wall-mount bracket and the fasteners required to secure the
controller to the bracket. The bracket allows the controller to be installed
perpendicular to the wall or at an angle, in 30 degree increments.
1. Install the bracket on the wall with 3/8-in. fasteners (not included).
2. Install the controller on the bracket with the supplied screws and
washers, including the single dished washer. The washer provides a
ground connection between the controller and the bracket.
3. Use the bus-bar grounding kit to connect the controller ground stud to
the booth base, as described in the grounding kit instructions.
Dished Washer
Figure 3-2 Wall-Mount Bracket Installation