Nordson Encore LT, Руководство по эксплуатации продукта

Страница: 63 / 92

Repair
6-7
Part 1604857-04
E 2014 Nordson Corporation
5. See Figure 6-8. Insert a small flat-bladed screwdriver behind the clear
pull tab at the top of the switch, then grasp the pull tab with a finger and
gently pull it away from the handle.
Figure 6-8 Removing the Trigger Switch from the Handle
6. To remove the switch, cut the ribbon cable, or feed the bottom of the
switch through the slot in the trigger recess and remove it from the
handle.
Switch Installation
NOTE: A new axle (23A) is included with a replacement trigger switch.
1. See Figure 6-9. Orient the new switch with the grid facing away from the
inlet tube, then carefully feed the square, bottom end of the switch (23)
around the left side of the inlet tube (25) and through the slot in the
trigger recess.
2. Peel off the small piece of tape holding the ribbon cable against switch.
Figure 6-9 Installing the Trigger Switch − Steps 1 and 2