Nordson Encore LT, Руководство по эксплуатации продукта

Страница: 54 / 92

Troubleshooting
5-6
Part 1604857-04
E 2014 Nordson Corporation
Spray Gun Power Supply Resistance Test
Use a megohm meter to check the resistance of the power supply, from the
J2 − 3 feedback terminal at the connector to the contact pin inside the front
end. The resistance should be between 280 − 320 megohms. If the reading is
infinite, switch the meter probes. If the resistance falls outside this range,
replace the power supply.
J2 − 3 (YELLOW)
FEEDBACK
J2 − 2 (BLACK)
COMMON
J2 − 1 (RED)
OSC
280 − 320 Megohms at 500 VDC
Figure 5-10 Power Supply Resistance Test
Electrode Assembly Resistance Test
Use a megohm meter to measure the resistance of the electrode assembly
from the contact ring on the back to the antenna wire in the front. The
resistance should be 19 − 21 megohms. If the resistance is out of this range
replace the electrode assembly.
19 − 21 Megohms
Figure 5-11 Electrode Assembly Resistance Test