6
' 3/
4
Unless you are using TCP/IP, it is not necessary to do this right now.
You can configure the network after the printer is up and running.
For complete instructions, refer to the
QMS CrownNet Setup Guide
.
/$) *!
1
Log on the UNIX system as root.
2
Edit the system host table by adding the following line to the
/etc/hosts file:
internetaddress hostname
where
internetaddress
is the Internet address of the printer
(Administration/Communications/Resident NIC/CrownNet/
TCPIP/Internet Address menu) and
hostname
is the name
of the host.
3
If necessary, set the hardware address.
Caution:
We strongly recommend that you do not change the
hardware address.
If you’re working on a system other than a UNIX system, set
the hardware address through the printer control panel.
If you’re working on a UNIX system, send the hardware
address to the print server by typing
arp -s
hostname
hardwareaddress
temp
↵
ping
hostname
↵
where
hostname
is the name of the host and
hardware
address
is the hardware address of the printer (in the form
##
.
##
.
##
.
##
as found on the printer startup page).
»
Note:
You can also send the hardware address of a UNIX
system through the BOOTP and RARP utilities.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
