6
6
!
7 ' 3/
)'012$* *!
Unless you want to use the default settings, use the following proce-
dure to name the file and print servers. These names must be unique.
»
Note:
In CrownAdmin, the printer shows up as
QMS_xxxx_Print_
System_hardwareaddress
, where
xxxx
is the printer model
number and
hardwareaddress
is the printer’s hardware address as
found on the printer startup page. This address will be blank until the
interface has been reset following installation.
1
In the Administration/Communications/Resident NIC/Crown-
Net/NetWare/Config PServer/File Srv Name[1], File Srv
Name[2], and File Srv Name[3] menus, enter the name of the
target file server (primary 3.
x
configuration server).
»
Note:
The three File Srv Name[x] menus allow you to identify 1
file server with a name up to 47 characters long. (Up to 16
characters can be entered in each of the 3 menus). You cannot
use these 3 menus to identify 3 file servers. Up to 16 file servers
are supported. To enter the 15 other file server names, use
CrownAdmin.
Spaces and lowercase characters are not allowed within file
server names. However, underscore characters ( _ ) are allowed
to simulate multiword names (for example, PUBS_SERVER). At
the printer control panel only, a space must be used following the
last character of the file server name to end the name. For
example, the file server name
FIRSTGROUP_GROUPS_BLUE_TEAM_TEAMS_CRC_QMS
is 42 characters long, and must be entered as follows:
FILE SRV NAME[1]
FIRST_GROUP_GROU
FILE SRV NAME[2]
PS_BLUE_TEAM_TEA
FILE SRV NAME[3]
MS_CRC_QMS<space>
where <space> is the space character.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
