Norcross ML100DR, Инструкция по эксплуатации

Страница: 8 / 21

L o c at i o n
Consult the boat manufacturer for the best in-hull transduc-
er placement. If this information is unavailable, follow the
guidelines below and see Figure .
• Outboard powerboats - Install as far aft as is practical
• Inboard / outboard powerboats - Install close to the
engine(s)
• Inboard powerboats - Install forward of the propeller(s)
and shaft(s)
• Sailboats - Install near the centerline of the hull and for-
ward of the leading edge of the keel
Deadrise Angle
Be sure the deadrise angle is less than 10 º
(see Figure 16 )
Figure 16
NO
YES
30
2. While the code is being gener-
ated the display will flash
“LEA” to indicate that it is in
LEARN mode. You may need
to slowly move the display
around the surface of the trans-
mitter until “LEA” is indicated
on the display.
3. Once “LEA” stops flashing the Code Learning process
is complete and you can now proceed with installation.
NOTE!!!!
If the depth sounder displays “E” constantly during
usage, the setup procedures on page 5 will have to be
repeated.
I
NSTALLING THE
T
RANSMITTER
(ML100T)
IMPORTANT!!!!
Please read the instructions completely
before proceeding with the installation.
* For optimal performance avoid installing the trans -
mitter in engine compartments where sound sup -
pression insulation may reduce the range.
* If the deck of your boat is constructed from metal
(aluminum, steel, etc) the transmitter will need to
be installed above deck.
7