Norcross ML100DR, Инструкция по эксплуатации

Страница: 16 / 21

If the problems are related to depth readings, please send
the transducer along with the unit when sending for repair.
We will not under any circumstances be liable to anyone
for any special, consequential, incidental, or other indirect
damage of any kind, except where incidental or conse-
quential damages are non-waivable as a matter of law.
NorCross goes to great lengths to provide the highest
quality products, engineered and manufactured under the
most stringent regulations in the world. We therefore
reserve the right to make changes or improvements in our
products without incurring the obligation to make these
changes on equipment previously manufactured.
This Limited Warranty is the sole and entire warranty per-
taining to the product, and operates in lieu of and to the
exclusion and/or limitation of all other warranties of any
nature, whether express, implied or extending from appli-
cation of law.
BATTERIES ARE NOT COVERED UNDER THE LIMITED
WARRANTY. PLEASE CONTACT NORCROSS CUSTOMER
SERVICE FOR BATTERY RELATED QUESTIONS.
Repairs Not Covered Under the Warranty
If upon receipt of the defective unit NorCross determines
that the defect is not covered under the NorCross Limited
Warranty, we will contact you about your repair options
and associated costs. We reserve the right to deem any
product unserviceable if replacement parts are no longer
available.
22
O
PERATING THE
W
IRELESS
D
ISPLAYS
The depth sounder’s auto-ranging, auto-sensitivity fea-
tures means that you never have to worry about adjust-
ments. Simply turn the power on, and your ready to go.
The transducer emits sound signals that travel through
water, and the depth sounder then
calculates the amount of time that
elapsed while the signal traveled
down to the bottom and returned
back to the transducer. This time is
calculated and is displayed as a
depth reading. Extremely dirt y
water, very soft bottom, high speeds, deep water, or a
combination of the above will result in incomplete or inac-
curate readings. Under these conditions variable readings
or “- - -” (Figure 9) will be displayed.
If the wireless display is not
receiving a signal from the trans-
mitter “E--” will appear in the
LCD (Figure 10). If this occurs
refer to the tro u b l e s h o o t i n g
guide for more information.
The display will show the current
depth upon power up. Both the
ML100R and ML100DR displays
will read “E” (Figure 11) if the
stored code does not match the
transmitters. If this occurs, the
setup procedures on page 5 will
have to be repeated.
Figure 9
15
Figure 10
Figure 11