Norcross ML100DR, Инструкция по эксплуатации

Страница: 11 / 21

“E--” Appears on the Display:
This indicates that there is no RF signal being
received from the transmitter
.
1. Make sure that there is power to the transmitter. (A red
or green LED on the transmitter will indicate power)
2. Move within range of the Transmitter.
2. Move the transmitter to a location that provides better
coverage. Larger vessels may require the transmitter
to be located in the center of the craft.
“E” Appears on the Display:
This indicates that the transmitter and receiver are not
matched. Refer to the Set Up section on page 5.
“LO” and the Depth Appears on the ML100R Display:
This indicates a low battery condition. Place the Display
in the charging cradle and recharge
.
There is interference to radio or television reception:
1. Reorient/Relocate the transmitter or wireless display.
2. Increase the separation between the equipment and
transmitter or wireless display.
3. Connect the equipment to a power source different
from that to which the transmitter or portable receiver
is connected.
27
I
NSTALLING THE
I
N
-D
ASH
W
IRELESS
D
ISPLAY
Installation of the In-Dash Wireless Display
(ML100DR)
1. Find a location on the boat that will allow clear viewing
of the LCD Display. Please keep in mind that the power
cable must reach the mounting location.
2. After finding the right location for the display, mark a 2-
inch hole to be cut using a 2-inch hole-saw (use the
template inserted in the manual marked Figure 4).
3. Check behind the desired mounting location for any
cables or wiring which could be damaged. Then cut
out the 2-inch hole.
4. Insert the display from the front of the panel, and install
the bracket and locking nut from the rear of the panel
(see Figure 5). Make sure that the face of the display
is rotated upright.
WARNING!!!!
Wear safety goggles and a dust mask.
IMPOR TANT!!!!
Please follow the Setup Procedures on page 6
and read the instructions completely before
proceeding with the installation.
10