Norcross ML100DR, Инструкция по эксплуатации

Страница: 4 / 21

FIGURE 10A
• This method is practical if the transducer will be located
near the stern and the boat has a low deadrise angle.
Clean away any large build-up of grease and / or dirt.
Place the transducer against the hull and allow bilge
water to cover the surface where they touch (see Figure
20 A).
FIGURE 10B
• If the hull surface is not smooth, grind it with a disc
sander. Coat the face of the transducer with petroleum
jelly and press it against the hull with a twisting motion
(see Figure 20 B).
CAUTION!!!!
Always wear safety goggles and a dust
mask when sanding.
Figure 20
A
B
C
34 3
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for com
-
pliance could void the user ’s authority to operate the
equipment.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: 1)
This device may not cause harmful interference and 2) This
device must accept any interference received, including
interference that may cause undesired operation.