MN700004 Rev 01
a
Preface
This guide provides the required information to setup and configure the ESB26 switch,
firmware version 3.3.0
. It is intended for network administrators who are responsible for
installing and setting up network equipment. It assumes a basic working knowledge of the
following:
•
Local area networks (LANs)
•
Ethernet concepts
•
Ethernet switching and bridging concepts
•
Routing concepts
•
Internet Protocol (IP) concepts
If the information in the Release Notes that are shipped with your unit differs from the
information in this guide, follow the Release Notes.
Conventions Used in This Guide
The syntax of CLI command lines, explained in "Basic CLI Operating Conventions" and the
further topics and discussed throughout this guide, is represented by the following general
format:
device-name
>
keyword(s)
[
parameter(s)
] ... [
keyword(s)
] [
parameter(s)
]
OR
device-name
[ (config ...)]#
keyword(s)
[
parameter(s)
]
... [
keyword(s)
] [
parameter(s)
]
where:
•
The angle bracket (>) is the CLI prompt symbol in View mode.
•
The pound symbol (#) is the CLI prompt symbol in all other modes.
•
The left part, up to and including the prompt symbol represents the command prompt
displayed by the computer. In this part:
device-name
stands for the name of the switch (e.g. ESB26).
The optional expression “(config)” or “(cfg ...)” – including the parentheses –
appears on the screen exactly as in the manual.
The part following the prompt symbol represents the users command. In this