NKT Photonics Koheras ACOUSTIK, Руководство по эксплуатации продукта

Страница: 55 / 96

55
Enabling emission from an individual BOOSTIK module
4 Before turning ON the BOOSTIK, check that
the input from the BASIK module is ON.
a In the Module overview panel, locate the
Power input field for the BOOSTIK and
check that the module measures a power
level between 10 to 200 mW. If so,
proceed to step 5.
b If no power is measured or it is low, locate
the
Actual power field for the source
BASIK module.
•
If there is no Actual power and
emission is OFF, repeat Procedure 5 .
•
If the emission power is low or you
cannot enable emission, swap the
ACOUSTIK module.
5
Note: Error code 60 - BOOSTIK emission enabled with no input. Enable BASIK emission and
re-enable BOOSTIK emission to clear the error.
6 a Set the emitted power level using the
slider in the
Power setting control. To
change the power, click-hold the red slider
to change its position.
b Alternatively, enter the power level in nW
units by typing the value into the text input
field at the upper right corner of the slider
control.
Action
Power measured
at the BOOSTIK
input
BASIK
Emission
ON
Status indicator ON
Click the Emission
button ON RED
Warning : Hazardous Class 4 emission
present, avoid both eye and skin exposure.
Click the Emission button once to turn ON the
BOOSTIK amplifier.
The Status indicator changes to ON GREEN
and the Emission button indicator turns ON
RED.
GREEN
Actual power field
measures output power
P slider
P input field