Sdasdasdsdfdsdcdscsdcdcd
cdcsc
9
Nitronic AG
Mattenstrasse 11
2555 Bruegg
Email: [email protected]
Switzerland
Phone: +41 32 373 70 70
Maintenance
Maintenance is limited to cleaning the stripping head.
Lubrication
The ST215 is designed so that no grease or oiling is required. In order to ensure good function and a
long service life, no greasy or oily substances may get into the device!
Cleaning
The stripping residues should be automatically removed from the stripping head by the compressed air jet
after each stripping operation. If this is not the case, start the machine again without the cable using the foot
pedal. If there is no foot pedal, insert the next cable. This is often sufficient to push stripping residues
away.
Clean the surface of the stripping head using a dry, clean brush only.
Dirt on the housing, the protective hood and the stripping head can be removed with a cloth lightly
moistened with benzine.
Do not use solvents such as nitro thinner!
Changing the stripping blades
The stripping blades may only be checked and replaced by
appropriately trained persons.
Remove the power cord, foot pedal and compressed air.
To facilitate the handling with the machine, arrange the machine
with aid of the bench clamp. See
Fig.
5
.
Set the diameter setting to 0.2mm (0.008 Inch).
Set the length setting to the hindmost position.
Fig. 5
