Sdasdasdsdfdsdcdscsdcdcd
cdcsc
5
Nitronic AG
Mattenstrasse 11
2555 Bruegg
Email: [email protected]
Switzerland
Phone: +41 32 373 70 70
Placing in operation
The sequence of the settings should be observed, since changes to the stripping diameter, due to
the design, require adjustments to the stripping length!
For adjustments on the stripping head, i.e. the centering unit or the stripping diameter, the protective cover
must be removed. It can be removed or reinstalled by simply pulling it out or pushing it in. The protective
cover must be pushed up to the front panel, remove any cable residues between protective cover and front
panel.
For safety reasons the machine cannot be started without the protective cover in place!
The blue LED flashes 3 times if an attempt is made to start the machine without the protective cover.
Setting the centering unit
Measure the external diameter, e.g. with the slide gauge or centering device open; introduce the
cable and close the centering device.
The cable must in no event be clamped but should be movable in the centering device without play.
Special regulations (e.g. military) require a blocking of the centering unit. This can be done with the
light-coloured Allen screw, use the supplied Allen key.
Do not confuse the light-coloured Allen screw with the black one. If you loosen the black Allen screw,
the centering device will be displaced and must be recalibrated.
Setting the Diameter
Evaluate the cable conductor diameter, e.g. with the sliding gauge.
Check that the Wayback is set to 0 (ST215W only).
Then set a slightly larger value on the diameter scale
(about + 0.1mm or 0.01 Inch)
. The division of
the diameter scale is
0.01mm (0.001 Inch)
.
When setting the diameter, always turn from a larger diameter to the desired value. For example, if
0.95mm is set and 1.00mm is to be set, then first open to approx. 1.50mm and then turn to 1.00mm
If the stripping diameter is set too small, the blades cut into the conductor and the insulation can only
be removed with high tensile force. This can damage the blades.
If desired, the diameter adjustment can be blocked with the supplied stud bolt. Remove the existing
stud screw on the side of the diameter adjustment with the supplied Allen key and carefully screw in
the longer stud screw until it stops.
