Sdasdasdsdfdsdcdscsdcdcd
cdcsc
6
Nitronic AG
Mattenstrasse 11
2555 Bruegg
Email: [email protected]
Switzerland
Phone: +41 32 373 70 70
Setting the Wayback (ST215W only)
The Wayback is an opening of the blades before pulling off the jacket. This allows a slightly deeper cut
without touching the conductor or shield during the pull-off.
The Wayback is only active when pulling off without rotation. The Switch 30 must be in the middle
position.
Set the Wayback to 0.00mm firstly
Raise the Wayback until the desired stripping results are reached.
The Wayback scale is graduated in
0.01mm (0.0005 Inch)
. That means that with a full turn the
Wayback will be 0.2mm (0.008 Inch) in diameter.
Setting the Length
Set the desired stripping length with the length setting knob and read off the length at the length
scale.
Fig. 3
