Sdasdasdsdfdsdcdscsdcdcd
cdcsc
10
Nitronic AG
Mattenstrasse 11
2555 Bruegg
Email: [email protected]
Switzerland
Phone: +41 32 373 70 70
Insert the position retainer into the stripping head as shown in
Fig.
6
by pushing the large Allen screw at the longitudinal scale to the rear. This makes it easier to insert
the new blades.
If the centering unit is blocked, loose the bright and small Allen screw.
Loose the black and small Allen screw of the centering unit.
Loose the entire centering unit and pull it out
Fig.
7
.
Fig. 6
Fig. 7
Now you can see the four stripping blades
Fig.
8
In order to avoid losing the very small stripping blades, we recommend that you put down a dark-
colored, smooth mat and use a pair of tweezers.
All four stripping blades must be changed at the same time in order to maintain a consistent
stripping quality.
Remove each stripping blade
(8)
individually from the guide
plate
(9).
If necessary, carefully clean the guide plate
(9)
with a dry
brush
Insert new stripping blades
(8)
individually. As far as possible,
align the stripping blades accurately with the track so that the
blades do not subsequently jam.
Insert the centering unit carefully, but
do not yet tighten it
.
Remove the position retainer.
Set the diameter scale to 0.0mm (0.0 Inch).
Fig. 8
