![background image](http://html1.mh-extra.com/html/nikon/lv-econ/lv-econ_instructions-manual_1690699032.webp)
30
The indicator in the CUBE area is lit while the conditions registered in the set-up memory are
used. When a button in the CUBE area is pressed, the indicator in the CUBE area is lit and
the microscopy method changes. And the indicator in the SET UP area turns off.
3
Set-up Memory Operation
This product has a memory area names as “set-up memory.” You can register three user-defined
settings of the microscope system into the set-up memory by using the special set-up software,
“LVSetup.” The registered data can be restored anytime you want. So, it is useful to register the
microscopy conditions you wish. When such conditions are registered, you can change
microscopies with the push of a button.
The following conditions can be registered in the set-up memory:
•
Microscopy method selection
(when the LV-UEPI2A is used)
•
Objective to be used
(when the motorized nosepiece or the motorized
DIC nosepieceis used)
•
Episcopic aperture diaphragm opening size
(when LV-UEPI2A is used)
•
Episcopic illumination condition
(on/off and brightness adjustment)
•
Diascopic illumination condition
(on/off and brightness adjustment)
•
Vertical position of the motorized focusing module
•
DIC prism condition
(when the motorized DIC nosepiece is used)
Registering conditions to the set-up memory
To register the user defined conditions to the set-up memory, run “LVSetup” with a PC. Connect a
commercially available USB cable to the PC. And then, run “LVSetup” to operate the setup
memory.
For details about registering user defined conditions, see “LV Series Support Tools software
manual.”
Restoration from the set-up memory
When one of the 1 to 3 button in the SET UP area is
pressed, the indicator of the button is lit and each device is
set to the registered conditions.
If no data is registered in the set-up memory and a button
is pressed, a beep sounds and the indicator remains unlit.
Besides, if some data are registered in the set-up memory
but some device cannot be enabled for some reason, a
beep sounds and the indicator of the button is turned off.
SET UP controls
Restoring settings from the set-up memory
After completion of restoring
Содержание LV-ECON
Страница 1: ...LV ECON E Controller Instructions M374 E 07 1 NF 2 2 3 ...
Страница 2: ......