V1.02
Thom Hogan’s Complete Guide to the Nikon D300
Page 300
two stops of your exposure are permanently encoded in only
two or three bits (that’s 4 or 8 possible data values!). That’s
just one reason why I say that obtaining a correct digital
exposure is important.
The D300’s exposure meter, while quite good, isn’t perfect.
So some photographers like to bracket their exposures (i.e.
take multiple exposures at slightly different settings).
The D300 has a very flexible bracketing system, allowing
between two and nine exposures to be taken at 1/3 stop, 1/2,
2/3, or 1 stop intervals. It also allows you to set white balance
bracketing instead of exposure bracketing (both can’t be set
simultaneously).
One thing that is going to frustrate D300 users is that Nikon
has removed the dedicated exposure bracketing button that
we used to have on the D200 and D2 series bodies. Instead,
bracketing is
one
of the possible assignments for the
Fn
button on the front of the camera. You must make sure that
the
FUNC
90
. dials
setting for Custom Setting #F4 is
set to
Auto bracketing
!
õ
To make exposure bracketing active (Custom Setting #F4
has to be at the default value):
1.
Hold down the
Fn
button while rotating the Rear
Command dial until
À
appears in the top LCD. When
this icon is displayed, exposure bracketing is active.
The Rear Command dial controls how many images
will be in the bracketing sequence (
3F
,
5F
,
7F
,
9F
is 3,
5, 7, or 9 images bracketed around the correct
exposure). Note that you may also set
-2F
,
+2F
,
-3F
,
and
+3F
, which are special bracketing variants not
centered on the correct exposure (see chart, below).
90
Anyone else notice the difference in naming? On the camera and in most places in
the manual the button is called
Fn
, while in some of the menus it is still called
FUNC
.