Nihon Bisoh BISOMAC308, Руководство оператора, Страница: 44 / 58

41
Nihon Bisoh Co., Ltd. BISOMAC308 1Phase&3Phase MM2015/9 KH-2015001
8. PERIODIC INSPECTIONS
The BISOMAC308 has to conduct the following periodic inspections if the
BISOMAC308 experiences the following conditions. The periodic inspections have to
be performed by certified personnel.
The following time periods should be used to determine to perform periodic
inspections. However, depending on job and environmental conditions, periodic
inspections may need to be done sooner.
A) Unit is more than 1 year old after purchasing
B) Unit over 1 year after previous periodic inspection
C) Unit operation hour is over 100 hours since last periodic inspection
D) When BISOMAC308 used in a bad work environment, such as dirt, dust, etc.
NOTE: Follow the Traction Hoist Maintenance Manual concerning periodic inspections.
WARNING
ALWAYS test and inspect the BISOMAC308 on a daily basis, otherwise the
BISOMAC308 may malfunction.
This may cause the platform to fall or tilt, and
consequently operators or objects might fall, resulting in serious injury, death or
damage to operators or passers-by.
WARNING
ALWAYS test and inspect the BISOMAC308 on a daily basis especially in work
environments that contain contaminants.
Maintain hoist (see maintenance manual)
after completing work at each work site to remove dusts and foreign objects inside of
hoist. Failure to do so may cause the platform to fall or tilt, and consequently operators
or objects might fall, resulting in serious injury, death or damage to operators or
passers-by.
WARNING
Only trained and certified personnel may replace the Brake, Motor, or Gearbox .
Otherwise, the BISOMAC308 may malfunction or not perform normally. This may
cause the platform to fall or tilt, and consequently operators or objects might fall,
resulting in serious injury, death or damage to operators or passers-by.
WARNING
DO NOT replace any BISOMAC308 parts with ones that are not approved. Such
replacement may cause the BISOMAC308 to malfunction or not perform adequately.
This may cause the platform to fall or tilt, and consequently operators or objects might
fall, resulting in serious injury, death or damage to operators or passers-by.