Nihon Bisoh BISOMAC308, Руководство оператора, Страница: 27 / 58

Nihon Bisoh Co., Ltd. BISOMAC308 1Phase&3Phase MM2015/9 KH-2015001
24
STEP 3 Main Wire Rope Reeving
A Insert the bullet end of the wire rope approximately 16 in. (40 cm) into the
suspension wire rope inlet of the BISOMAC308.
B Press the "UP" Button while maintaining downward pressure on the wire rope
until self-reeving starts.
C Make sure the wire rope can freely exit the BISOMAC308 and is not blocked
by any parts.
D Install the suspension wire rope so that rope-to-rope distance of platform side
and rigging side become equal.
E To avoid run off the suspension wire rope from the BISOMAC308, make the
loop on the end of the suspension wire rope and fix it using the clamp as
shown in the illustration.
STEP 4 Mounting BISOMAC308 to the platform
Press the “UP” Button to lift the BISOMAC308 from ground so that the hole in the
Fold-Up Stirrup Bar and the hole in stirrup are lined up, and then attach the hoist to
the stirrup as shown in below with 2 Special Bolts, 4 Washers and 4 Nylon (provided
by Nihon Bisoh). Position of the Rope End should be outside of the platform as
shown. Use Torque Wrench to tighten the Bolts
Torque Standard: 76 N
･
m (770 kgf
･
cm)
Fig. 4
Rope End
Clamp
Suspension Wire Rope