Nihon Bisoh BISOMAC308, Руководство оператора, Страница: 38 / 58

35
Nihon Bisoh Co., Ltd. BISOMAC308 1Phase&3Phase MM2015/9 KH-2015001
CAUTION
When oil is leaking from BISOMAC308, stop using BISOMAC308 and replace
with a defect-free product.
Reduction in the amount of oil increases the temperature of the Gear Reducer which
may cause burn injury. Besides, operating it at high temperature may emit smoke from
Gear Reducer and it may not be possible to ascent or descent the equipment.
WARNING
If the BISOMAC308 has a defect, replace it with one that has passed the
pre-shipment inspection by certified personnel.
BISOMAC308, which has not
passed the pre-shipment inspection, may malfunction or not perform normally. This
may cause the platform to fall or tilt, and consequently operators or objects might fall,
resulting in serious injury, death or damage to operators or passers-by.
WARNING
DO NOT use the BISOMAC308 if the Overspeed Detection Device does not
engage the wire rope.
Replace it with a properly operating Overspeed Detection
Device, failure to do so may cause the suspension wire rope to be cut, the platform to
fall or tilt, and consequently operators or objects might fall, resulting in serious injury,
death or damage to operators or passers-by.
7.1 Test Procedure for Rigging
Inspect all components of the suspended platform, especially the components
supporting loads, to be sure there are no signs of damage or excessive wear and
that all fasteners (nuts, bolts, clamps, wire-clip, shackle, etc.) are properly and
securely tightened.
7.2 Test Procedure for Wire Rope
7.2.1 Profile and Dimension of Wire Rope
•
Wire rope MUST be taken out of service when ANY of the following
conditions apply, refer to Picture.2.
WARNIG: TEST PROCEDURE OF CONTROLLED DESCENT DEVICE
WARNING: TEST PROCEDURE OF OVERSPEED DETECTION DEVICE