Height Rider/SP Series
Operating & Safety Instructions
English/USA – 01/18
Original instructions
42
2)
Check batteries for state of charge, damage, dirt, etc. Ensure batteries are
fully charged
before
storage. If no use of the platform is intended, an occasional "top-up" charge of the batteries will
serve to equalise their charge level.
Never leave in a state of discharge for any length of
time
. Refer to HR12 MK2 Service Manual for further information.
3)
Leave battery disconnect switch in
OFF
position to prevent discharge of batteries through
leakage.
4)
If machine is to be left on an incline, chock wheels to prevent creep.
5)
If machine is to be left outside or in a hostile environment, cover with suitable weatherproof
media to prevent deterioration.
4.7.5
SETTING TO WORK
Before use each day and at the beginning of each shift the machine shall be given a visual and
functional test including, but not limited to, the following
1)
Check all lubrication points for adequate application of grease, oil etc.
2)
Inspect all threads for ease of operation - especially descent valves, brake release valve etc.
3)
Check level and quantity of oil. Remove any contaminants - water, etc.
4)
Check batteries for electrolyte and state of charge.
5)
Check electrics for damage and insulation.
6)
Using ground controls, cycle machine over complete envelope in accordance with the Operating
Instructions. Cure any defects.
7)
Ensure that all safety devices and controls operate in accordance with the instructions.
8)
If necessary, perform a load test to establish the machine stability before putting the machine to
work.
9)
On completion of an extended period of road transport, the machine might need additional
inspection to identify any transit degradation, which could render the machine unsafe. Perform
a Pre-delivery Inspection on the unit before it enters service. Record any faults found and rectify
them immediately.
10)
If left un-attended for an extended period, it is likely that the hydraulic cage levelling will become
un-pressurised. Normal operation is then lost, with a noticeable delay in the forwards or
backwards motion as the booms move. To restore normal function, operate the cage-levelling
function at the Ground Control Station, the cage needs to be fully levelled forwards and
backwards. When the system has been charged in both directions, the cage levelling function
should be restored. Repeat the procedure as described above until the movements are smooth
and un-interrupted. If in doubt, contact our Service Department for further advice.
Niftylift Limited is not liable for any third party damage caused during transport. Careful attention to
correct procedures will prevent many of the small snags that can happen in transit. Re-work is both
expensive and time consuming. A defective machine arriving at the place of work is a poor
advertisement for our product, the company’s reputation and those of our dealers and clients. The
responsibility for safe and damage-free transport rests with the haulier or their representatives.
Содержание HR 12
Страница 77: ......
