Nidek Medical ME 1200, Руководство по установке

Страница: 46 / 60

38
CHECK AND ADJUSTMENT PROCEDURES : Polishing Adjustment
6) Change the parameter value with the
numeric keypad. Enter the value and press
the
button.
When the front surface of the bevel remains
unpolished, increase the value.
When the rear surface of the bevel remains
unpolished, decrease the value.
2
Press the Exit tab to return to the layout
screen.
3
Repeat Steps 1 and 2 until the bevel is properly
polished.
4
Process the other lens materials and change the other Bevel position parameter in the
same manner.
3.8.3 Adjusting the polish axis
■
Check the bevel polished surface of a plastic lens processed with the circle 45 internal data. If the
right or left of the lens edge remains unpolished, change the Polish axis parameter.
1
Decrease "CR39, Flat" of the Polish differential parameter by 0.2.
See “3.8.1 Lens edge is left unpolished or burnt” (page 36).
2
Change the Polish axis parameter.
1) Display the menu screen in service mode.
See “3.2.1 Entering service mode” (page 16).
2) Press the Grinding tab on the menu
screen.
The Grinding screen is displayed.
• When the bevel position is changed, the polish bevel position is also moved. As long as the
polish bevel position is properly adjusted, it does not need to be adjusted again even if the
bevel position is changed afterward.
Front surface remains unpolished.
Rear surface remains unpolished.
2) 2)