28
CHECK AND ADJUSTMENT PROCEDURES
:
Drilling Check and Adjustment
3.6.3
Adjusting the hole depth
■
Adjust the hole depth in the following procedure when the hole depth is outside the setting range
after the drilling confirmation shape is checked.
1
Display the menu screen in service mode.
See “3.2.1 Entering service mode” (page 16).
2
Press the Grinding tab on the menu
screen.
The Grinding screen is displayed.
1) Press the Adjustment button.
2) Press the Hole button.
3
Adjust the hole depth.
Press the "Depth adjustment" numeric
field.
Change the parameter value with the
numeric keypad. Enter the value and
press the
button.
When holes (1) to (3) are all drilled,
the reference value of Depth adjustment is -0.2 mm.
When holes (1) to (3) are not drilled at all,
the reference value of Depth adjustment is 0.2 mm.
4
Press the Exit tab to return to the layout screen.
5
Repeat processing the lens with drilling confir-
mation shape data and Steps
1
to
4
until the
hole depth becomes proper.
2
1)
1)
2)
2)
3
Содержание ME 1200
Страница 6: ...IV ...
Страница 10: ...2 REQUIREMENTS Requirements ...
Страница 58: ...50 CHECK AND ADJUSTMENT PROCEDURES Clock Check ...
