31
CHECK AND ADJUSTMENT PROCEDURES
:
Drilling Check and Adjustment
3
3.6.5
Adjusting the front surface offset
■
Adjust the front surface offset in the following procedure when the front surface offset is outside
the setting range after the drilling confirmation shape is checked.
1
Display the menu screen in service mode.
See “3.2.1 Entering service mode” (page 16).
2
Press the Grinding tab on the menu
screen.
The Grinding screen is displayed.
1) Press the Adjustment button.
2) Press the Hole button.
3
Adjust the front surface offset.
1) Press the "Front surface offset"
numeric field when the hole positions
of (7) and (8) are not aligned.
The numeric keypad appears.
2) Change the parameter value with the
numeric keypad. Enter the value and
press the
button.
When the 30º tilt hole is drilled on the 0º hole,
decrease the parameter value.
When the 30º tilt hole is drilled under the 0º hole,
increase the parameter value.
2
1)
1)
2)
2)
3
Содержание ME 1200
Страница 6: ...IV ...
Страница 10: ...2 REQUIREMENTS Requirements ...
Страница 58: ...50 CHECK AND ADJUSTMENT PROCEDURES Clock Check ...
