NF HVA4321, Инструкция по эксплуатации

Страница: 83 / 152

4.3 Operation example in constant current mode (load)
HVA4321
4-27
！
！
4.3 Operation example in constant current mode (load)
This section describes operation example of this unit in load mode of constant current mode.
In constant current mode, the output current varies according to the input signal.
In load mode, load current is correctly controlled ignoring effect due to leak current with cable capacity.
Effect of stray capacitance of the cable is found only for AC signal output. Effect of stray signal is not
found for DC signal. Therefore, use the unit in total mode for DC signal.
In load mode, leak current with stray capacitance and load current are detected from different routes.
Therefore, load mode cannot be used for load which is grounded.
When the internal high voltage DC power supply is ON and SIGNAL is ON with the output open,
maximum ±12 kV output is given to the OUTPUT Hi terminal. It is very dangerous. Do not turn ON
SIGNAL when the output is open.
In constant current mode, be sure to connect load or short-circuit the output.
When the internal high voltage DC power supply is ON and SIGNAL is OFF with the output open, ±100V
voltage output may be given to the OUTPUT Hi terminal depending on the voltage limiter settings.
In constant current mode, DC cannot be run for capacity load. At this time, the output for DC signal is the
same as that in open status. When SIGNAL is ON, maximum ±12 kV output is given to the OUTPUT Hi
terminal.
Never apply DC to capacity load in constant current mode.
WARNING
WARNING