Page | 26
Again, ideally the cameras themselves as well as 3Play should be genlocked. If cameras are not genlocked
to the same reference signal as 3Play, a TBC (Time Base Correction) operation is automatically applied.
Time base correction may drop or insert frames as necessary to maintain sync, a less desirable approach.
Note: For a deeper explanation of genlocking, please see Section 7.1.2.
3.8
CONFIGURE VIDEO INPUT
Let’s continue by configuring the video sources you connected earlier (Section 3.3):
1.
With the Replay Desktop open, roll your mouse into the footer below any input monitor.
2.
Notice that a Configure button (gear icon) appears at right below the input monitor as you do so.
Figure 28
3.
Click the Configuration button (gear) for Camera 1 to open a settings panel (Figure 28).
4.
Click the Input Settings tab.
5.
Click the Connection Type menu to reveal a listing of various options.
6.
The Format menu will usually auto-detect the correct setting, but you can make a manual
selection here for the video source you plan to connect to this input if auto-detect is unsuccessful.
At this point you should be able to view the (configured) sources on their respective monitors. Before
closing the Configuration panel, let’s continue to configure the related audio source.
Содержание 3Play 3P1
