25
Model:
Netti Dynamic S
Language:
English
Version:
2021-03
My-Netti.com
6.16 ADJUSTING THE ARM SUPPORT
• The arm supports are adjusted by opening
the arm support lock.
• Pull the arm support up or down.
• A scale on the vertical profile helps defining
same height on both sides.
The arm pad can be adjusted back and forwards
by loosening the screws under the arm pad profile.
Push the arm pad to desired position and fix. On top
of the armrest pads soft armrest cushions can be
slipped over. Remove when a table is mounted.
2 positioning screws allow for limiting
the height. Position them where they are
needed.
6.15 SIDE SUPPORT
The back cushion can be sideways stabilized /
reinforced by mounting side supports.
They are mounted to the back profiles and can be
height and width adjusted to give the user optimal
side support.
To Mount:
• Fold the back forwards to a horizontal position.
• Insert 2 M6 square nuts into the back profile.
On the lower end of the profile a opening allows
for the nuts to enter into the slot.
• Push the nuts upwards.
• Lay the side support on top of the profile as
shown on the illustration and fix with screws
entering into the 2 square nuts.
• Adjust the height and width of the side support.
Check that the back cushion cover the side
support with no hard edges.