21
Model:
Netti Dynamic S
Language:
English
Version:
2021-03
My-Netti.com
6.10 ADJUSTING THE SEAT PLATE
DEPTH
The seat plate can be depth adjusted in 5 intervals
(250 – 275 – 300 – 325 and 350 mm) without change
of parts except replacement of seat cushion to a
depth equal to new seat depth.
ADJUSTMENT IS DONE AS FOLLOWS:
• Remove the cushions.
• Pull the armrest up to max height or remove
them.
• Remove the lower cloth protectors by unscrewing
the 2 screws holding them.
• Swing the seat plate upwards to get access to the
screws sitting on its side.
• Remove the screws on each side and pull or push
the back part of the seat plate to desired seat
plate depth.
• Insert the screws and fix.
• Replace all components.
ATTACHING THE GAS SPRING UNDER THE CHAIR
In order to achieve a 90° position of the backrest the
position of the gas spring under the chair has to be
changed when the seat depth is adjusted. The hole
where the back hinge is mounted follows the hole in
the bracket where the cylinder is mounted.
Back hinge position Cylinder position
If special user needs demands a different
angle than the recline function allows, the
position of the gas spring can be adjusted.
When changing seat depth, you also change
the tipping point of the chair.
This can be prevented by changing the
position of the main wheel in the main
wheel bracket (see chapter 6.6).