20
My-Netti.com
Model:
Netti Dynamic S
Language:
English
Version:
2021-03
6.9
ADJUSTING THE SEAT DEPTH
AT THE REAR
•
The seat depth can be adjusted in 6 intervals
(250 – 275 – 300 – 325 and 350 mm) without
change of parts.
•
Small adjustments are done by adjusting the
straps on the Velcro backrest.
ADJUSTMENT IS DONE AS FOLLOWS:
•
Open the backrest lock and fold the backrest
forward in the chair.
•
Remove the screws for adjusting the seat depth
on both sides and move the back-rest hinge
to the required seat depth.
•
The backrest hinge must be in the same positions
on both sides.
• Tighten the screws.
• The recline gas spring must change position
so that the backrest angle equals 90° when the
recline gas spring is in the end position.
6 mm Allen-key.
13 mm open-end spanner.
FINDING CORRECT SEAT DEPTH:
• Remove the leg support and head support.
• Adjust the seat to a horizontal position.
• Open the backrest angle slightly to make it easier
for the user to get the bottom well into the chair.
• Adjust the backrest cushion height to give the
user good lumbar support.
• Correct seat depth depends on the user’s thigh
length and is measured while seating.
When the seat depth is correct, there should
be approximately 20 – 30 mm distance
between the front edge of the cushion
and the hollow of the knee.