Getting Started
7
WN804 Access Point
Front Panel
The access point front panel has the status LEDs shown in the following figure.
Figure 2. Access point front panel
Table 1. Front panel LED descriptions
LED
Description
Power
•
Solid amber
. The access point is starting up.
•
Blinking amber
. The firmware is upgrading, or the Reset button was pressed.
•
Solid green
. The access point is ready.
•
Blinking green
. The firmware is corrupted. Visit
www.netgear.com/support
.
•
Off
. Power is not supplied to the access point.
WiFi
•
Solid green
. The wireless radio is operating.
•
Off
. The wireless radio is off.
Internet
•
Solid green
. The Internet connection is ready.
•
Solid amber
. The Ethernet cable connection to the modem has been detected.
•
Off
. No Ethernet cable is connected to the modem.
WPS
•
Slow blinking
. The LED lights for 5 seconds if WPS setup fails.
•
Blinking
: WPS activity is in process.
•
Off
. No WPS activity or no WPS failure was detected.
The WiFi and WPS buttons on the side of the access point toggle the WiFi and WPS
functions on and off.
•
WiFi On/Off button
.
Pressing and holding this button for 2 seconds turns the wireless
radio on and off. If the WiFi LED is lit, the wireless radios is on. If this LED is off, the
wireless radio is turned off and you cannot connect wirelessly to the access point.
•
WPS button
. You can use this button to use WPS to add a wireless device or computer
to your wireless network. The WiFi LED blinks blue when the access point is trying to add
