Virtual Private Networking Using IPSec and L2TP Connections
223
NETGEAR ProSAFE VPN Firewall FVS318G v2
You can print the following table to keep track of this information.
Use the NETGEAR VPN Client Wizard to Create a Secure Connection
You can set up the VPN client in two different ways:
•
Configuration Wizard
. The Configuration Wizard configures the default settings and
provides basic interoperability so that the VPN client can easily communicate with the
VPN firewall (or third-party VPN devices). The Configuration Wizard does not let you
enter the local and remote IDs, so you must manually enter this information. Of the two
methods, the Configuration Wizard is the easier and preferred method. For more
information, see
Use the NETGEAR VPN Client Wizard to Create a Secure Connection
on page 223.
•
Manual Method
. Instead of using the wizard on the VPN client, you can manually
configure the VPN client. For more information, see
Manually Create a Secure
Connection Using the NETGEAR VPN Client
on page 228.
Note:
Perform these tasks from a computer on which the NETGEAR
ProSafe VPN Client is installed. The VPN client supports IPv4 only; a
future release of the VPN client might support IPv6.
Table 44. Information required to configure the VPN client
Component
Enter The Information That You Collected
Example
Pre-shared key
I7!KL39dFG_8
Remote identifier information
remote.com
Local identifier information
local.com
Router’s LAN network IPv4 address
192.168.1.0
Router’s WAN IPv4 address
192.168.15.175