26
MaxiMailer HD Operator Manual
True Weight:
This shows the weight of the document or insert in the units
shown, and is linked to
Thickness
above. To enter a known weight, press
the ‘Computed’ button to uncheck the box, and then click the ‘True Weight’
button. Enter the required figure in the units shown. Note that if this function
is used
Paper Weight
will not be active. The true weight need only be
entered if Postage Rates are being used (see page 36).
OMR name:
Press this button if you are using OMR, then press the
name
button and select an OMR setup (see page 20 for defining OMR setups).
label name:
Select if you are using barcodes or other labels, then press
the
name
button and select a label setup (see page 23 for defining barcode
setups).
note: OMR or barcode reading are optional features.
X / y / lx / ly:
Specify the X and Y dimensions to the centre of the marks
or label, as indicated in the graphic. Specify the length of the marks or label
for vertical (Ly) or horizontal (Lx) reading.
Document ID:
Optional Feature.
Used to verify that the correct stationery
is loaded into the correct feed unit. If using this feature, set ‘Doc ID Mode’ to
ON and define the alpha-numeric characters being used for the ID. Note that
the start position and length of the characters must be set in the Barcode/
Label screen.
Document address:
If this is the address document, press the ‘Address
Position’ button and select the position that best describes the location of the
address - this will be used by the software to determine the type of fold and
orientation of stationery. Note that the left/right location of the address is not
stated, as this will be determined by the printed address matching the lateral
position of the envelope window. If it is not the address document, select
‘None’.
Press the ‘Save as Default’ button if you wish this to be the setup that new
documents will default to.
When all editing is complete, press the
save
button at the bottom of the
screen, and then the
exit
button to return to the list box.
Notes:
1. Minimum document width in the pack (including inserts) must be no smaller
than the maximum document width by more than the following: Minimum
document width = (Maximum document width/2) + 58mm. eg. if maximum
document = 210mm, minimum document width = (210/2) + 58 = 163mm
minimum.
editing the
settings.
(contd.)
Содержание MaxiMailer HD
Страница 67: ...67 MaxiMailer HD Operator Manual...
Страница 68: ...68 MaxiMailer HD Operator Manual 13 DECLARATION OF CONFORMITY Maximailer HD...
Страница 69: ...69 MaxiMailer HD Operator Manual...
