Installation and Upgrade 2-17
Memory Compartment
Follow these steps to upgrade the memory modules.
1.
Power off the system and disconnect any peripheral devices.
2.
Turn the system over and locate the screw on the memory compartment.
3.
Remove the screw and open the memory compartment by lifting its upper
side.
4.
Locate the alignment notch on the module.
5.
Locate the memory module sockets. Your system comes with one module
already installed in the socket. When installing additional memory, use the
other empty socket.
6.
Align the notch with the notch in the socket connector and insert the module
as follows:
Hold the SO-DIMM at a 60-degree angle and align the SO DIMM
connector with the socket in the system. Push the connector into the
socket.
Press down on the edge of the SO-DIMM until the locking tabs on
the sides snap into place, securing the module.
7.
To remove a SO-DIMM, press the locking tabs away from the sides of the
module until the module pops up. Then, remove the SO-DIMM.
8.
Reassemble the Versa Note components as follows.
Replace the DIMM door back.
