NEC POWERMATE ES Series, Инструкция по обслуживанию и справочник

Страница: 63 / 132

Disassembly and Reassembly 3-15
3.
Lift the back of the drive slightly and slide it forward to engage the two tabs on the bracket
with their slots in the front panel.
4.
Align the screw hole at the end of the bracket with its corresponding hole in the chassis.
5. Install the previously removed screw through the bracket and into the chassis to fasten the
bracket in place.
6.
Lift up the cable retainer on the drive connector and insert the drive cable into the
connector. Push down on the retainer to lock the cable into the connector. Check that the
cable is secured.
7.
Replace the system cover (see “System Cover Removal” earlier in this section).
Hard Drive Removal
Remove the hard drive as follows.
1. Remove the system cover (see “System Cover Removal” earlier in this section).
2.
While pressing the device bracket lock on the side of the bracket, raise the bracket up
enough to unplug the CD-ROM drive cables.
3. Raise the device bracket up to its vertical position (see the following figure).
4.
Remove the hard drive screw (
B
). Loosen but do not remove the accessible shoulder
screw ( C ).
Removing the Hard Drive
A – Device Bracket Lock C – Shoulder Screw (1 of 3)
B – Hard Drive Screw D – Shoulder Screw Slot (2)
5. Remove the hard drive as follows.
!
Tilt the device bracket slightly from its vertical position, enough to allow access to the
front of the drive.
!
Slide the hard drive towards the rear of the chassis until the shoulder screw is aligned
with the vertical shoulder screw slot.
! Lift the drive straight up, following the path of the shoulder screw slots on each side of
the drive bay.
6.
Unplug the power and signal cables from the hard drive.