3-2 Disassembly and Reassembly
This section contains step-by-step disassembly procedures for the PowerMate ES SlimLine
Series system. A disassembly figure is provided with most procedures. For an illustrated parts
breakdown and parts list, see Section 5, “Illustrated Parts Breakdown.”
For complete disassembly of the system, follow the disassembly order listed in the following
table. To reassemble, follow the table and procedures in reverse order. Where reassembly is not
apparent, reassembly procedures are provided.
A small flat head screwdriver, Phillips-head screwdriver, and needle nose pliers are the only
required tools.
PowerMate ES SlimLine Series Disassembly Sequence
Sequence
Part Name
See Page
1
Slimtower stabilizer
3-3
2
System cover
3-4
3
DIMM module
3-6
4
Processor
3-8
5
Expansion board
3-10
6
5 1/4-inch device
3-12
7
Diskette drive
3-13
8
Hard drive
3-15
9
CMOS battery
3-17
10
LED board assembly
3-19
11
Riser board
3-19
12
Power supply
3-20
13
System board
3-21
When disassembling the system, follow these general rules.
!
Turn off the system and unplug the AC power cord.
!
Disconnect all peripherals before disassembling the system.
!
Before handling boards or chips, touch the frame to discharge static.
!
Do not disassemble parts other than those specified in the procedure.
!
All screws are Phillips-head, unless otherwise specified.
!
Observe each cable connector before attempting to disconnect. Some connectors have a
retainer holding them in place.
!
Wherever possible, label any connector before disconnecting it. Note where the connector
goes and in what position it was installed.
!
Use care in disconnecting cables. To prevent cable breakage, pull only on the connector. Do
not pull on the cable.
!
When installing a cable, route the cable so it is not pinched by other components and is out
of the path of the cover.
On completion of any reassembly, perform a power-on test. If a fault occurs, verify that the
reassembly was performed correctly.
Содержание POWERMATE ES Series
