NEC N8100-1575F, Руководство пользователя

Страница: 330 / 378

11-16 Upgrading Your Server
Removal
Remove the DIMM according to the following procedure.
NOTES:
„
To remove the defected DIMM, check the error message appearing
in POST or NEC ESMPRO to identify the DIMM socket in which
the defected DIMM is installed.
„
The server needs at least one DIMM installed to operate.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Open the levers at both ends of the socket for the DIMM to be removed.
The lock is released to allow the DIMM to be removed.
3.
Install the components you have removed in Step 1.
4.
Power on the server. Make sure that no error message appears in the POST.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 10.
5.
Select "Yes" for [Reset Configuration Data] on the [Advanced] menu.
This is required to update the hardware configuration information. See Chapter 4 for
details.
6.
If you have replaced the failed DIMM with new one, run BIOS SETUP and select
[Advanced]
→
[Memory Configuration]
→
[Memory Retest]
→
[Enabled], and reboot the
server.
This is required to clear the error information of the removed DIMM. See Chapter 4 for
details.
7.
Set the paging file size to the recommended value or a greater value.
See Chapter 5, 6, or 7 for details.