NEC N8100-1575F, Руководство пользователя

Страница: 128 / 378

4-52 Configuring Your Server
Clearing CMOS Data
1.
See the section "Preparing for Installation and Removal" in Chapter 11 to prepare.
2.
Remove the server from the rack (see Chapter 11).
3.
Remove the top cover (see Chapter 11).
4.
Locate the position of the jumpers on the mother board you are changing.
5.
Change jumper switch setting from "Protect" to "Clear".
6.
Wait for a while (about 5 seconds), and then reinstall the jumper block to the default
position.
7.
Reassemble the server, and press the POWER switch to turn on the server.
8.
Press F2 during POST to run the BIOS Setup utility, and execute [Load Setup Defaults]
on the Exit menu.
Clearing Password
1.
See the section "Preparing for Installation and Removal" in Chapter 11 to prepare.
2.
Remove the server from the rack (see Chapter 11).
3.
Remove the top cover (see Chapter 11).
4.
Locate the position of the jumpers on the mother board you are changing.
5.
Change jumper switch setting from "Protect" to "Clear".
6.
Reassemble the server, and press the POWER switch to turn on the server.
7.
Press F2 during POST to run the BIOS Setup utility, set the password again, and execute
[Exit Saving Changes] on the Exit menu.