9-1
MH110/MH120 IP Wireless Telephone Setup and Administration Guide - Revision 1
9
Certifying MH110/MH120 Mobile
Handsets
This chapter explains how to conduct a preliminary Site Survey Mode
test. Areas where coverage is conflicting, inadequate, or where there
are system difficulties should be noted and discussed with your wireless
LAN and/or LAN system administrator to determine the cause and
possible remedy. Refer to
Chapter 11, “Troubleshooting Mobile Handset
Problems”
for clues to possible sources of difficulties.
Chapter Topics
• Site Certification
• Site Survey Mode
• Solving Coverage Issues
Site Certification
The installer should not leave the site before performing
installation verification.
These tests must be performed in typical operating conditions,
especially if heavy loads occur. Testing sequence and procedure is
different for every installation. Generally, you should organize the test
according to area and volume, placing numerous calls to others who can
listen while you perform coverage tests. Note any areas with excessive
static or clarity problems and report it to Customer Service.
The coverage test will also require you to put the Mobile Handset in
Site
Survey Mode and walk the entire coverage area to verify all access
points.
IMPORTANT
The installation is not complete until these certification steps have
been performed. Do not hand out Mobile Handsets at a site that has
not been certified.
Содержание MH110
