NEC Express5800/R120b-1, Руководство пользователя

Страница: 388 / 580

9-32 Upgrading Your Server
Removal
Remove the DIMM using the following procedure.
NOTE:
To remove the failed DIMM, check the error message
appearing in POST or NEC ESMPRO to identify the DIMM socket
(group) in which the failed DIMM is installed.
1.
See page 9-4 to prepare.
2.
Pull out the server from the rack (as described on page 9-4).
3.
Remove the top cover (as described on page 9-24).
4.
Open the clips at each end of the socket from which you remove the DIMM.
The DIMM pops out of the socket.
5.
Hold the DIMM by the edges, lift it away from the socket, and store it in an anti-static
package.
6.
Reinstall all parts removed in Steps 3 to 7.
See installation procedures for detail explanations.
7.
Power on the server and verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed on page 8-10.
8.
Run the BIOS SETUP utility and select [Advanced]
→
[Memory Configuration]
→
[Memory Retest]
→
[Enabled] to clear the error information of the removed DIMM. (See
page 4-13 for details.)
This setting is required to update the hardware configuration information. See page 4-8 for
details.